4/2/2023 0 Comments Horsehair plaster![]() ![]() I can't put greenboard drywall in because there's a gas line going up through the plaster (see red rectangle image below) and the drywall will stick too far out to line up with the window trim/sill. Horsehair plaster was a common type of plaster. Horsehair plaster usually was attached to lath strips. If the area is large you may have to add some backing to it like a piece of wood. Smooth with a sponge, rag or putty knife if it is a smooth wall. If you’re renovating an older or historic property at the moment, you may well have come across horsehair plaster, also referred to as lath and plaster, typically a mixture of horsehair, plaster, sand and lime. It's not a very thick layer but because it's uneven, some parts will be thicker. Ceiling joist Gypsum Top plate board Plaster Wall Stud Figure 7-4 : Cross - section of a residential. Fill in the damaged areas with joint compound or spackling. I'm looking to basically fill in what the wainscoting was covering up so I'll need to even it up with the board above it. Even today, when it is a whole era of Drywall, some people still prefer using the Horsehair Plaster for the renovation of their homes. Because the plaster has alkaline in it, the longer the hair, the better it would be to maintain it. ![]() Plaster was used typically in pre-war homes and is now used to keep the historical authenticity in a home. But later in 1950s, the Drywall began to replace the plaster. Horsehair plaster hasnt been used in the market for some years now because it is prone to cracking after aging. If the plaster proves difficult to shatter, use a large sledgehammer to pound the plaster until it cracks and breaks. Then use gloved hands to remove the large chunks that break away. When the plaster dries those pushed-through parts contract and stick, hard, to the back of the lathe forming what are called 'keys'. Can you remove horsehair plaster Use a hammer to break a hole in the horse-hair plaster. It seems to have taken some moisture damage as well as it's powdery and crumbles to the touch. Specifically, in Canada and US, the Horsehair plaster was being used until 1950s. When plaster is installed it is sort of a stiffish glop, and it is pressed against the underlying lathe layer some of the plaster is smushed through the openings between the lathe rows. The plaster is very uneven as it looks like the wainscoting was used to cover it up directly and there's no finish/sealer on it. Under one of the walls is an exposed horsehair plaster that was done right up against the brick/studs. I've taken wainscoting off of my bathroom wall that seems to have been around since the house was built (1900). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |